Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
VanagonEuroVan

Search messages and discussions

Clear search

Search preserved mailing-list messages and current email and website contributions. Current posts are searchable before weekly archival. Recovery gaps remain possible. Words are matched together; try fewer terms if needed.

Page 4: 17 results shown for Wire grommets.

Source-balanced relevance: matches from both collections are interleaved, with source dates breaking ties. Restoration time is not the original posting date.

  • Re: Replacing the master cylider
    Historical mailing list - Jim Johnston
    Fri, 9 May 2008 13:14:05 -0400
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • 84 1.9 lifter collapse & CA smog - HC's issue (sorry it's so long)
    Historical mailing list - Leonard Anthony
    Sat, 19 Sep 2009 15:19:50 -0700
    ...02 sensor plugs, cap, rotor & wires. All intake gaskets compression 150 on all 4. fairly new AFM all this on a VW reman with...
  • Re: Master Brake Cylinder Install
    Historical mailing list - Joel Cort
    Sat, 2 Sep 2006 21:18:30 -0700
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • Re: Brake master cyclinder replacement procedures (LONG)
    Historical mailing list - Joel Cort
    Mon, 17 Jul 2006 19:43:33 -0700
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • Re: Instructions for trans mount and master brake cylinder
    Historical mailing list - Jim Johnston
    Thu, 10 Sep 2009 08:26:40 -0400
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • Fwd: Brake master cyclinder replacement procedures (LONG)
    Historical mailing list - Jim Johnston
    Fri, 9 May 2008 13:13:11 -0400
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • Re: Replacing the master cylider - In Bentley?
    Historical mailing list - BJ Feddish
    Fri, 9 May 2008 13:29:17 -0400
    ...I also disconnected the low fluid sensor wire on the MC filler cap. Step 2. Check for similarities with the new one: Ok double...
  • some stuff i did to my buses ...
    Historical mailing list - Joel Walker
    Sun, 14 Jan 2001 23:53:35 -0600
    ...it was a bit of a pain to snake the wires around, and feed and pull them through the rubber grommets, but i think...
  • CAT HEATER INSTALLATION IN VANAGON
    Historical mailing list - harald.nancy
    Thu, 2 Oct 1997 17:09:12 -0700
    ...Run a hot 12 volt wire from the battery or other source to the "cat". Make sure your installer puts in a " Inline fuse...
  • Re: Speaking of modifications...
    Historical mailing list - Joel Walker
    Sat, 6 Apr 2002 01:31:34 -0600
    ...it was a bit of a pain to snake the wires around, and feed and pull them through the rubber grommets, but i think...
  • Re: vanagon syndrome week - Friday
    Historical mailing list - Doug in Calif
    Fri, 10 Jun 2005 17:51:13 -0700
    ...While it's up, I may as well drop the fuel tank and > replace the grommets. Then I broke the auto tranny while "fixing...
  • Re: Fuel leak
    Historical mailing list - Joe L.
    Mon, 30 Nov 1998 20:35:57 -0500
    ...Two Grommets (about $2 each) 2. Three feet of 5mm gas line (the stuff running from the plastic jugs to the tank. The good...
  • Re: trip
    Historical mailing list - David Beierl
    Fri, 10 May 2002 13:41:25 -0400
    ...100-ft 12-ga *flexible - the limper the better* extension cord, also phone cord one-into-two adapter, 100 feet of phone wire with...
  • Trip Report: Hunting Island, SC (long, propane, Garmin IQ3600 GPS)
    Historical mailing list - Edward Maglott
    Sat, 2 Apr 2005 23:00:36 -0500
    ...When you want to use it hand held, it just snaps out with the press of a button, no worries about unhooking the wires...
  • Re: Radiator part 2 Disappointment and install hints
    Historical mailing list - kenneth wilford (Van-Again)
    Fri, 10 Mar 2023 11:26:16 -0500
    ...Once they are removed you can pull/tap/pry the large metal wire like twisty part of the spare tire carrier out of both...
  • Re: Radiator part 2 Disappointment and install hints
    Historical mailing list - kenneth wilford (Van-Again)
    Fri, 10 Mar 2023 11:45:40 -0500
    ...Once they are removed you can pull/tap/pry > the large metal wire like twisty part of the spare tire carrier out of both...
  • for campers: Propane Safety
    Historical mailing list - J. Walker
    Tue, 01 Nov 94 10:55:51 CST
    ...Use rubber grommets or plastic-wire loom material to protect the gas line from rubbing where it passes through metal walls. Install gas line...