Woody, I just had to overcome the same problem.  Find the appropriate
electrical schematic.  Disconnect connector from ECU along with connectors
from Temp Sensor II and Ignition Control module (pinouts are marked on that
connector).  On my '84, pin 1 of connector to ECU goes to pin 7 of ignition
control.  I used ohm meter to confirm connection and the double checked by
ohming out pin to Temp Sensor II

John Lauterbach
Macon, GA

----- Original Message -----
From: Woody Halsey <WoodyHalsey@COMPUSERVE.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Monday, January 03, 2000 4:34 PM
Subject: dumb question dept

Dear List,

Please forgive me, but I have flipped through the Bentley twice and cannot
find the picture of the multipoint connector  to the ECU that identifies
all the pins. Can someone give me the page reference? I know it's in there
somewhere.

Thanks!

Woody