Terry,

Check to see that the CVs bolts are not loose or that a wheel is not
loose or bent.  The joints can be lubed in place using the following
method.

Get an end for a grease gun that goes to a tube or point and matches some
smaller plastic tubing in size.  Slip the plastic tube on the end and
slip it past the boot ... I used a screw driver to help make a spot for
the tube to enter.

Squeeze the recommended grease (I use high temp moly) into the boot area
near the joint.  Then kneed the boot a little to move some grease into
the joint.

Good luck

George Lehman
1982 Westy bought new in '82
________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.