Phil-

I have photos and diagrams of the 1600 heat stuff. I will do my best to
scan/post today. I have a full schedule this a.m. (Eastern Time zone), but
should be able to do by 18:00.

G. Matthew Bulley
Bulley-Hewlett
Corporate Communications Counselors
www.bulley-hewlett.com
Cary, NC USA
888.468.4880 tollfree

"I, the undersigned, shall forfeit all rights, privileges, and licenses
herein and herein contained, et cetera, et cetera . . . fax mentis
incendium gloria culpum, et cetera, et cetera . . . memo bis punitor
delicatum!" It's all there, black and white, clear as crystal!      -Wonka

-----Original Message-----
From:   Phil Marston [SMTP:pmarston@INSTECH.CO.UK]
Sent:   Monday, January 10, 2000 3:37 AM
To:     vanagon@GERRY.VANAGON.COM
Subject:        Aircooled Rear Heater Hose Assembly

 << File: ATT00004.htm >> Hi All,

Just drove my T25 for the first time to work this morning & it was so cold.
I really need to get my heater system to work so that I don't freeze to
death &
so I can see where I am going.
I have read the comments & web pages and can see what needs to be done
as regards insulation etc... but I have a more fundamental problem than
that.
I have no hose assembly between the fan on the back of the alternator (1600
aircooled) and the two heater exchangers.  Must have been lost in the mists
of time by a previous owner(s).
Does anybody have a picture or diagram of what is required ? (or a web page
I can refer to).  The rest of the system is still intact & I have new heat
exchangers etc..
Thanks in advance
Phil
T25 with no heat !!