Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
VanagonEuroVan
Subject:Re: Freeing Rear Brakes
From:Stanley, Kerry
Date:Sat, 22 Jan 2000 18:03:23 -0500

Hi all,

Someone once posted to this list the only solution that worked for me.  In
most cases the drum will not come off because it is seized/rusted at its
mating surface to the hub.  I soaked the studs with penetrating oil and then
banged on the drum, but directly onto the face of the drum.  But of course
this is hard to do with the 5 studs poking out!!  So use some drift or short
metal bar or something to place in between the studs and smack this with a
hand sledge.  Go around the drum, and I bet it pops off.

Kerry
'86 syncro 171K
kstanley@cas.org

-----Original Message-----
From: Paul Borghese [mailto:PAUL98@PRODIGY.NET]
Sent: Saturday, January 22, 2000 2:02 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Freeing Rear Brakes

Reach around behind the wheel to the rear of the drum (opposite of where you
put the tires :-).  There is a 1/2 inch or so hole behind the back.  You may
need to remove a rubber protective plug to get at it.  You can then use a
flat screwdriver to ratchet the brakes away from the drum.

I would bang a little harder on the drumb with a hammer.  I was surprised
how much force was actually required to loosen the drum from the rust
build-up.

Good luck,

Paul Borghese

-----Original Message-----
From: mwilliamson <mwilliamson@USWEST.NET>
Newsgroups: groupstudy.vanagon
Date: Saturday, January 22, 2000 7:39 AM
Subject: Freeing Rear Brakes

>Hello all-
>I set about to renew the brakes on the transporter last week end.  Front
>brakes pads went as smoothly as always.  However, when I tried to tackle
the
>rear brakes, the drum is on so tight that I cannot remove it to get at the
>"works".  Can anyone help me understand how to free them up?  I rapped on
>them with a mallet and drove around, but in the end make no progress.
>
>My Haynes manual indicates that through some (unidentifiable to me) port I
>can slacken the brake for just this sort of need.  I wish I could tell that
>I can see it.
>
>Any suggestions/help is appreciated!
>--
>Mark A. Williamson
>Denver, CO
>88 Wolfsburg Multivan (160K)
>95 Golf (62K)
>---

Have something to add on this topic today? Revive this thread in the forum »