Dear List,

When I installed my shiny new Temp 2 sensor, I noticed that there was no
seal on the old one. I am assuming there is meant to be a brass washer of
some sort. Can someone please confirm size, composition and perhaps even
P/N? Thanks.

BTW, I took her out for a spin on the highway to see if the new Temp 2
improved performance. It did not, and a little coolant began to leak from
around it as soon as I got up to operating temps. I am going to wait for
the seal and the new FI harness before cranking up again. If the new
harness doesn't make any difference, I'll check fuel pressure and
compression and then try the new fuel pressure regulator.

Also, can someone point me to the intake manifold on my 1983.5 1.9? Robert
Keezer tells me that if there is any fuel in there, it's a sure sign that
the FPR is shot.

Again, thanks,

Woody