

| Subject: | Re: Tranny oil change: How to *not* do it. |
| From: | Dana Morphew |
| Date: | Tue, 1 Feb 2000 18:07:01 -0800 |
On the ACW tranny, the air hole is just to the left, (front is front), of the upper left M8 bolt that holds the gear carrier housing to the tranny housing. -Dana- Stuart MacMillan wrote: > > Martin, > > Vanagon trannies are vented and should not build up any pressure, your > vent must have been plugged. I don't have the Bentley in front of me, > but if you feel up around the top of the tranny you should find a raised > plastic cap that covers the vent hole. Check it when you change the > fluid to make sure there is not a build up of dirt here. > > If pressure builds up too high for too long you will eventually blow oil > past the seals, not a good thing! > > Martin Jagersand wrote: > > > > I was startled when suddenly the plug flew out of my hand, followed > > by a jet stream of hot tranny oil soaking me completely. Took me > > precious seconds to roll out of the way of the oil shower and > > manuever the drain pan in my place. > > > > All soaked I contemplated my mistake. It had been a cold, crisp morning > > when I test opened the fill plug. At that point I had pressure equalized > > the tranny to the high denstiy of the cold morning air. Plugging the > > tranny back up and driving it to the aut store had heated it up > > from maybe 5C to 50-60C. Normally the trannies are supposed to pressure > > equalize slowly, but apparently not this one. Hence when I opened the > > drain plug the oil was under pressure. > > > > > Cheers, > > Martin > > -- > > Westy 1.9l Turbo Diesel > > Quantum 1.6l Turbo Diesel > > > > New and used parts for sale, gas and Diesel: > > > > http://www.cs.yale.edu/~jag/vw/forsale.html > > > > Martin Jagersand email: vwjag@hammer.cs.jhu.edu > > Computer Science Department > > Johns Hopkins University > > > > Slow down and visit the VW diesel Westy page: > > WWW: http://www.cs.rochester.edu/u/jag/vw > > ------------------------------------------------------------------- > > -- > Stuart MacMillan > Manager, Case Program > 800-909-8244 ext. 8208 > > Getting your share of the Net yet? > http://cobaltgroup.com > http://UsedEquipNet.com
Have something to add on this topic today? Revive this thread in the forum »