Sean,

Loosen the small case bolts above and below the pump and pry gently and
evenly with two screwdrivers, one on each side.  You can break the ears
off, so if it is really tight go to your favorite VW FLAPS and get a VW
oil pump puller (same as for air cooled engines), should be under $20,
and use it.  Be sure to get four new sealing nuts while you are there,
don't reuse the old ones, and don't forget to tighten up the case bolts!

Sean Garrett wrote:
>
> I tried to remove my oil pump and was unsuccessful. After removing all 4
> bolts I pried lightly on the 2 opposing tabs that stick out. It seems that
> its really tacked on there good (with some permatex I bet). How mush
> pressure should I put it under and are there any other methods I could use?
>
> Sean
> 80 Westy
> ______________________________________________________
> Get Your Private, Free Email at http://www.hotmail.com

--
Stuart MacMillan
Manager, Case Program
800-909-8244 ext. 8208

Getting your share of the Net yet?
http://cobaltgroup.com
http://UsedEquipNet.com