This would work OK for turning it, but I don't see how you could put a
hose on the bleeder, in order to do the bleeding....... you know,
other end of hose in a jar of brakefluid..???

-----Original Message-----
From: Jimmy Sanby <SanbyJ@telkom.co.za>
To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM>;
mccomas@shore.intercom.net <mccomas@shore.intercom.net>
Date: Monday, March 13, 2000 5:12 AM
Subject: Re: brake shoes cont..... 7mm wrench

|I use a 7mm allen drive with a �" socket, no bending etc required.
|
|>>> McComas_Glenn <mccomas@SHORE.INTERCOM.NET> 03/13/00 11:36AM >>>
|Lee Roesner, Northbrook Office, wrote
|........ going out tomorrow to buy fluid and a 7mm wrench (right one
I
|hope?) and
|bleed brakes.
|
|Lee,
|The typical 7mm box wrench will be lots easier to use if you take it
|someplace where they have an acetylene torch.  You want to bend a
deep
|offset....... mine is about 2" at say 60�.  Heat it cherry red just
|past the box end, bend; then repeat ~2" along, bending in the
opposite
|direction.  Plays hell with the chrome; saves your knuckles.....
|
|