In a message dated 3/27/00 5:57:19 PM Eastern Standard Time,
LISTSERV@GERRY.VANAGON.COM writes:

<< Heads/Cylinders somewhat naive question!!! >>

    David, you should have pulled the motor in the first place.  Makes the
whole job a lot easier.  You will be much better off to pull the motor now
and do it right.  You will need to use a spring compressor to get the
cylinders back on.  The best way to compress the rings is to use a large
diameter hose clamp which you will find at your local FLAPS.  Change the
O-rings on the bases of your cylinders.  This is one of the reasons I
recommend pulling the engine and removing the cylinders anyways.  I always do
it this way.  Even if the cylinders do not come off with the heads, once the
tension on the cylinders has been released by undoing the head bolts these
O-rings may not seal again.  Therefore the need to replace them.  I think I
just wrote about this yesterday .....check the archives.  And, good luck !

Cheers

Frank Condelli
'87 Westy & Lionel Trains
STEBRO/Vanagon Stainless Steel Exhaust Systems
Almonte, On
Visit me on the web.......> <A
HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli & Associates<
/A>  or
http://http://onward.to/frankcondelli
Want to win $10,000? Click to enter!!
 <A HREF="http://irecommend-it.com/sh.e?22EC343C3B75">iRecommend-It Public
Page for RAlanen@aol.com</A>