In a message dated 3/28/00 7:29:40 PM, kdosmm@WORLDNET.ATT.NET writes:

<< On my 1984 GL, the insulation is worn down to bare wire where it goes under

the heat shielding covering the push rod tubes.

Does anyone have any ideas on how to reinsulate the wiring? >>

Scott,
Do not re-insulate, remove and replace the wiring with Teflon insulated wire.
 I think I used 20ga on mine.  Do yourself a favor and take the trouble to
scrounge up a few feet of the Teflon insulated wire; miles from now it will
prove worth the effort.  Also, make certain the wire is not pinched between
the engine tin and the head.
Rich