My question has been answered thanks to
Bob Donalds from Boston Engine.
Harald
'90 westy
----------
> From: harald_nancy <harald_nancy@earthlink.net>
> To: vanagon@GERRY.VANAGON.COM
> Subject: Need advice inner cylinder sealing ring
> Date: Tuesday, April 04, 2000 6:09 PM
>
> Hi all,
> Have my engine taken apart at a local shop to have
> new cylinder heads and piston kit installed.
> Today when I looked at it, I noticed that the mechanic
> must have slipped with the piston pin reamer, and
> a small chip is missing exactly in the corner where
> the lower rubber sealing ring for the cylinder liner goes.
> I am kind of upset about this, especially since the case
> is in such good condition.
> The mechanic and shop foreman tell me that it's no
> big deal, and they will use 570 locktite (?) sealant to fill it
> the chip.
> The rubber sealing ring alone would not seal the chip,
> it's probably too deep.
> Maybe some of you can think of another alternative.
> I'm not a big fan of gooey sealants bridging gaps.
> I'm sure it would hold up long enough for the warranty to be over.
> Any opinions are welcome.
> Harald
> '90 westy