>Hey, does anyone out there have an uncracked expansion tank for the
>cooling system for a 1.9L (this one is an 83.5)? The plastic tank that
>you fill the cooling system from?
>
>Or better yet, does anyone have reassuring tales of how to glue or
>otherwise repair the seam that splits at the bottom?
>
>Please reply direct, as I am not on the gerry list.
>
>Thanks
>
>Dan Fleming
>San Diego

Hi Dan,

     My expansion tank cracked at the top, between the pressure cap
and the sensor. I tried JB weld but no way would it hold. Eventually,
I ordered a brand new OEM tank from Bus Depot. At $29.95, it was worth
it & it had the added advantage of being able to see the coolant
again without having to peer through a layer of crud!

     *Warning* - when ordering the tank, order the coolant level
sensor o-ring. This *must* be replaced! When I replaced my tank, I
re-used the o-ring against the advice of the folks on the list
(hiya Joel! 8-) ). I coated the o-ring with silicone & tightened it
down well. Did it leak?? Yup! 8-) The new o-ring was well worth the
$1.49 that Ron charges.

Pete C

--
Peter Cassidy,                   pcassidy@apple.com
Sr. Test Dev. Engineer             +353-21-284316
WW Operations
Apple, Cork.