Couple of suggestions...

!. letting the fluid flow form the resevoir out of the bleeder nipple on the
slave cyl all by itself. Of course attach a tube from the nipple to a
container. Very slow.

2. better. reverse bleed the system. pump the fluid in from the slave to the
resevoir. A couple of assumptions...you have already flushed the system with
your attempts to bleed (get no dirty fluid in the resevoir) and that you
have a pressurizable container to deliver the fluid.

The second method really does work.

Alistair

>HELP!  I can not get system to bleed.  Have tried pressure from
>reservoir and vacuum from slave cylinder without success.  I have
>disassembled and thoroughly cleaned master cyl including the 2 holes
>under the reservoir tube.  Cleaned 3 small holes in piston.  Everything
>looks good.
>
>Only possibile problem I can see, perhaps the forward (in direction of
>flow) cup .
>
>Could this swell with age and prevent the valve action of the thin
>washer over the 3 small holes in the piston.
>
>Mast cyl is FAG if there are different ones used.
>
>Any/all suggestions appreciated.
>
>I have tried all morning to search the archives and I continually get a
>msg that gerry is to busy to use right now.
>