Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
VanagonEuroVan
Subject:<no subject>
From:Todd Kaderabek
Date:Mon, 19 Jun 2000 08:54:18 -0400

Date:    Sat, 17 Jun 2000 22:24:27 -0700
From:    Bjorn Ratjen <BRatjen@direct.ca>
Subject: blinking oil light

Volks,=20
I came across a problem where I would need some helpful hints: Upon start
everything is normal, all lights go out. Once the engine revs over 2500rpm
the oil light starts blinking and the buzzer sounds. When you shut of the
engine and start again the buzzer is quiet again until you accelerate the
engine. There is enough oil in the engine. The engine has just been rebuilt
completely. The oil pump is okay. There are two new oil sensors in the
engine and the wiring connections seem to be fine.=20

I can only think of two suspects: the control chip in the dash or the
pressure release valve. Any other ideas or hints on what to test? The
Bentley manual has some testing procedures but they are in the end not
really conclusive in this case.

Thanks for suggestions.

Bj=F6rn
---------
Almost certainly the oil pressure sensor in your dash has gone bad.  Same
thing happened to me, replacing the sensor cured the problem immediately.
Oddly, it happened to me directly after an engine rebuild as well.  I wonder
what the connection could be?

TJK
--

Have something to add on this topic today? Revive this thread in the forum »