

| Subject: | Re: Knocking engine? or hyd lifters? how to tell? |
| From: | Bulley |
| Date: | Wed, 2 Aug 2000 18:13:17 -0400 |
You're the nice J.Peters, right? Kewl.... You are right on track with the compression check. If your motor otherwise has good compression, it will point you to the correct cylinder(s). In my experience, even the filthiest lifters will EVENTUALLY pump up after 10-15 minutes of driving. Adjust your valves per Bentley, Haynes, or Boston Bob. Go for a spin, and wait for them to pump up. Lifters, however don't usually make a knocking sound...more like a TACK, TACK, TACK, TACK, TACK TACK, TACK, TACK, TACK. A knocking sound THACK-A, THACK-A, THACK-A, THACK-A is upper end bearings. A deep, THOCK, THOCK, THOCK, THOCK is lower end. A main bearing can be quiet, or can sound like all hell breaking loose, depending on severity and location of the bearing. G. Matthew Bulley, Principal Consultant Bulley-Hewlett Corporate Communications Mount Olive, NC USA 877.658.1278 Tollfree www.bulley-hewlett.com My Agenda: Vanquish Suburban Sprawl. My Methods: Revitalize mature urban towns. Champion mass transit and fast Internet service. Demand replacement of archaic, "separationist" zoning laws with neo-traditional mixed-use zoning. The Result: Exceptional living/working alternatives; restrained sprawl; our children inherit walkable, beautiful, interlinked towns. Find out more at http://www.cnu.org -----Original Message----- From: james peters [SMTP:rickenhacker@hotmail.com] Sent: Wednesday, August 02, 2000 3:16 PM To: vanagon@GERRY.VANAGON.COM Subject: Knocking engine? or hyd lifters? how to tell? OK here it goes. My 80 vanagon has a terrible knock! This occured after it sat for a couple days. (Back in July 11) Had the heads done in Nov 99. I took some advice from the list and replaced a couple of supposed bad lifters, I might have changed the wrong ones, because its still knocking. Now, is there a way to tell where the bad lifter (if that is the case) is located? I tried listening with a stethascope (SP) even a huge screwdriver, but I can't tell where the knock is coming from. If I do a compression check, would the reading tell me which hyd lifter is bad? I haven't tried the ATF/MMO trick yet, but I need advice. I can't see the forest because of the trees. Its also too hot in Sacramento to be outside wrenching on the van. TIA, Rick ________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
Have something to add on this topic today? Revive this thread in the forum »