On Thursday, August 10, 2000 9:53 PM, Reynolds John <kayakjr@juno.com>
wrote:
>
> I found a miidle seat, with arm rests! in a abiut to be junked vanagon.
 I
> could not see the sliders (evene after picking up the carpet.  Bolts were
> evidnet in the cross bars that spanned the length of the set.  My
question
> is too fold - could I be overlooking the sliders?  And is it possible to
> find and fir the sliding mechanism to this seat to use in my Westy?
>

John:

You probably can't see the sliders while the seat is installed.  Remove the
metal sill from the sliding door (4 screws?)  Move the carpet out of the
way.  Lift out the cut-out piece of insulation board.  Remove the 4 bolts
from the cross bars at the base of the seat.  Slide the seat out toward the
sliding door.  You will then see the rails.  You will also then see the 4
bolts that hold the rails down to the floor.

I'm planning to fit one to my Westy also.  I haven't yet down it, but I'm
quite encouraged by the number of list members that have or have seen it
done.

Maynard
'82 Westy Diesel "Reinhardt"
'93 EV GL "Klinger"
'00 Golf GLS TDI "WooHoo"
'84 Jetta GL TD