In a message dated 9/5/00 11:36:17 PM Eastern Daylight Time,
Lee.Peterson@NEXTEL.COM writes:

<< I just got a table/side panel from a carat or wolfsburg in the mail from a
 guy in CA.  I didn't get any attaching hardware or extra parts with it.  Has
 any one done this conversion into a regular 7 pass GL?  I think I am missing
 some parts to hold in the top of the panel.  Where do the table support bars
 bolt into inside the side panel?  I am sure someone else has gone through
 this!!
 Lee >>

youre most likely missing parts, as most people forget to remove all the
table hardware.   also, i dont know if you know this or not, but if you use
the carat/wolfy side panel, then you must use the carat/wolfy rear bed....
sorry to bring bad news..  but the carat/wolfy side panel sticks out so that
your back seat or bed wont fit.  the carat/wolfy rear sofabed is narrower
than the regular weekender rear sofabed.
chris
'84 wolfy w/ carat interior going into it..