

| Subject: | Re: Sliding door supposed to stay open? |
| From: | Jeffrey R |
| Date: | Sun, 1 Oct 2000 19:14:15 EDT |
In a message dated 10/1/2000 2:38:44 PM Pacific Daylight Time, ingalls_mark@HOTMAIL.COM writes: > If I'm parked on a slight incline and open my sliding door is it supposed to > latch into a detent somewhere and stay open? > Yes but you have to park with the front of the bus facing up the hill :) Ok truthfully, my 83.5 has a simple spring-loaded hook that holds the door open. The hook is located about midway up on the door about an inch or three above the inside door handle (or handles). The hook is in the door jam however, not on the door--mounted at the "C" pillar on the outside of the bus--but hidden from view unless the door is open. This hook, when the door is all the way open, latches to a catch on the front inside of the door. The visual here is a little complicated using words, but remember with the door sliding back the front of the door becomes about flush with the rear side of the door opening-- or to say it another way, flush with the C pillar. Anyway on the inside of the front of the door, again about an inch or three above the handle there is a cigarette pack sized plastic rectangle that clips over the interior door panel and that has the reciever latch for that hook in the back. That rectangle, when the door is slid open, slides back to the C pillar and the latch then gets clipped by the hook and that keeps the door open. On mine the spring is weak so the spring sometimes pops off. You've just reminded me to replace it once and for all. While I have been able find the spring each time it comes off, perhaps the previous owner of your bus was not so lucky. Without the spring to force the hook onto the latch the hook will not catch and therefore the door will not stay open. If all is working properly you have to disengage the hook to close the door which is done by pushing the inside door handle forward, or pushing the outside door handle down. This releases the hook by moving the latch clear of its grasp. Depending on what year you have the set up may be different. But that's how it works on my 83.5. My guess is you can get the spring at the VW dealer fairly cheap in the scheme of things. If you can see the spring installed on another bus you will see it's pretty easy to install--it just snaps into place. But to explain it here might be near impossible. Having said all that, you could have a problem with the latch and not the missing spring. But it's a place to start. Good luck Jeff 83.5 Westy NV
Have something to add on this topic today? Revive this thread in the forum »