

| Subject: | Re: Power windows go CLUNK! |
| From: | Todd Last |
| Date: | Tue, 24 Oct 2000 20:37:51 -0700 |
I think that this is what happened to me - at least from your description. I'll have to take a closer look. I looked in the ETKA CD and it appears that there are only two parts to the power windows. The motor and the track/cable assembly. Thanks, I'll give the new bolt/nut a try first. Todd Bill Davidson wrote: > Todd, > not sure from your description if this is the case... > > but it is fairly common for the elbow fitting that holds the cable to break > where it is bolted onto the frame the window guides move up and down on.... > I fixed mine by fabricating a new bolt to install it back into place... but > had to remove the motor, open it up, unwind some cable to get slack... > rebolt elbow in place with fabricated bolt/nut (after several trips to the > hardware store to get the right thing)... then rewind the cable on the > motor.. reinstall motor, etc.... hold breathe to make sure it works.... > > but it involved so much work that I think it would be easier to buy a whole > new mechanism if your time is worth more than your labor... I don't think > the part is available by itself and even if it were you'll have to unwind > the cable from the motor to thread the cable through the elbow... a job... > > but like I said... from your description it's hard to tell what part you are > talking about.... so not sure this applies.... > > Bill > > ----- Original Message ----- > From: "Todd Last" <Rubatoguy@MINDSPRING.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Tuesday, October 24, 2000 6:47 PM > Subject: Power windows go CLUNK! > > > I went to roll my power window down and was met with a loud clunk. After > > opening the door panel, it appears that part of the black plastic > > housing broke that is near the track at the rear of the driver's door. I > > can still see the cable that threads through it. > > > > Can you get parts for just this piece? Or do I have to replace the whole > > motor assembly? > > Is this a common failure, or is there something I can do to prevent the > > other power window assembly from breaking in a similar manner. > > > > > > Todd > > > > '88 Westy > >
Have something to add on this topic today? Revive this thread in the forum »