I'm getting about ready to install my type RV engine from an '89 Jetta
into my '90 Vanagon.

I have carefully cut off the mount for the power steering fluid
reservoir.  It was right where the rear end of the right engine carrier
will attach.  I want to use the power steering rack the Vanagon came
with but not have a pump providing assist.  The wheels are manageably
turnable without the power assist even when using the original, smaller
diameter, steering wheel and at a standstill.  I'm leaving the supply
and return lines in place though, so I can reengineer a powered setup if
desired.

Will I damage any part of the power steering rack by using it as a
manual system?  Does the power steering fluid provide necessary
lubrication to steering parts in the front end?

Thank you for your advice and comments.

-Dana-