The easiest thing to do get a power steering pump setup from a 2.0L Audi
80/90 engine with the code "3A" is it uses the same power steering pump as
the Vanagon and it will be a "plug and play" event.  Other VW pumps will
also work you will just have to get the ends of the PS lines changed to
match.

David Marshall

Fast Forward Autobahn Sport Tuning
4356 Quesnel Hixon Road
Quesnel BC Canada  V2J 6Z3
mailto:info@fastforward.ca      http://www.fastforward.ca
Phone: (250) 992 7775           FAX: (250) 992 1160

. Vanagon Accessories and Engine Conversions
. Transporter, Unimog and Iltis Sales
. European Lighting for most Audi and Volkswagen models

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
Of Dana Morphew
Sent: October 26, 2000 11:29 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Power Steering Used as Manual Steering

I'm getting about ready to install my type RV engine from an '89 Jetta
into my '90 Vanagon.

I have carefully cut off the mount for the power steering fluid
reservoir.  It was right where the rear end of the right engine carrier
will attach.  I want to use the power steering rack the Vanagon came
with but not have a pump providing assist.  The wheels are manageably
turnable without the power assist even when using the original, smaller
diameter, steering wheel and at a standstill.  I'm leaving the supply
and return lines in place though, so I can reengineer a powered setup if
desired.

Will I damage any part of the power steering rack by using it as a
manual system?  Does the power steering fluid provide necessary
lubrication to steering parts in the front end?

Thank you for your advice and comments.

-Dana-