OK...good.  Thanks David and Don for the counsel.  I will look for the
pump mount, pump, get the reservoir mounted, and run with power
steering.

-Dana-
>
>
>The easiest thing to do get a power steering pump setup from a 2.0L Audi
80/90 engine with the code "3A" is it uses the same power steering pump
as
the Vanagon and it will be a "plug and play" event.  Other VW pumps will
also work you will just have to get the ends of the PS lines changed to
>match.
>

David Marshall

Fast Forward Autobahn Sport Tuning
4356 Quesnel Hixon Road
Quesnel BC Canada  V2J 6Z3
mailto:info@fastforward.ca      http://www.fastforward.ca
>Phone: (250) 992 7775           FAX: (250) 992 1160
>

>
> Dana,
>
> About a year ago I decided to have the steering rack on my '87 Wolfy looked
> at. When I pulled into the shop and the mechanic took a look at it, he
> asked, "Did you drive this in here?"
> "Of course", I said.
> "The shaft gears are completely toast", he said.
> "Oh my God, I just got back from SLC yesterday! That's 2000 miles round
> trip!"
> "You lucky bastard", he said.....
> He put the van on a lift and proceeded to show me what happens to the power
> steering rack when it doesn't get the required fluids.
> See, my van's steering pump was bad when I her. But I drove on it for about
> 2 years before having it looked at.
>
> So, lesson to be learned? Power steering racks sure for power steering. They
> will wear out Very fast if not lubricated properly, and that could cause a
> major accident (imagine your bus taking off in it's own direction at
> 60+mph!!)
>
> I had the mechanic convert the powered rack to a standard, unassisted rack
> from VW. I love it. Super stable, and turns nice and easy. But, it did cost
> me about $1300 with parts and labor.
>
> So, there's my 2c.
>
> Lates,
>
> Don Preston
>
> -----Original Message-----
> From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
> Of Dana Morphew
> Sent: Thursday, October 26, 2000 11:29 AM
> To: vanagon@GERRY.VANAGON.COM
> Subject: Power Steering Used as Manual Steering
>
> I'm getting about ready to install my type RV engine from an '89 Jetta
> into my '90 Vanagon.
>
> I have carefully cut off the mount for the power steering fluid
> reservoir.  It was right where the rear end of the right engine carrier
> will attach.  I want to use the power steering rack the Vanagon came
> with but not have a pump providing assist.  The wheels are manageably
> turnable without the power assist even when using the original, smaller
> diameter, steering wheel and at a standstill.  I'm leaving the supply
> and return lines in place though, so I can reengineer a powered setup if
> desired.
>
> Will I damage any part of the power steering rack by using it as a
> manual system?  Does the power steering fluid provide necessary
> lubrication to steering parts in the front end?
>
> Thank you for your advice and comments.
>
> -Dana-