At 01:13 11/8/2000, Stacy Schneider wrote:
>    Has anyone done this?If so could you help me along,it's on my list of
>things which need to be checked off.

Keep taking stuff off until you get to the actual circuit board -- there
will be two places next to each other where two adjacent pads could be
bridged by a solder drop.  The clock I looked at was built with copper
bridging the 24-hr pads, then this was scratched out and the 12-hr pads
were soldered together.  Anyway, clean the solder off the 12-hr side and
solder across the 24-hr side.  Use a small clean iron (</= 25W) and go
easy.  You can solder a tiny wire across if the solder drop doesn't want to
bridge the gap easily.

david
David Beierl - Providence, RI
  http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage"
'85 GL "Poor Relation"