on 11/15/2000 10:00 PM, Bradley Flubacher at flubach@HOME.COM wrote:

> must you drain the coolant to replace the temp 2 sensor?  Or just bleed it
> afterward?  Or neither?
> 
> Thanks,
> Bradley Flubacher
> State College, PA
> 

(Not speaking for the 2.1, but they prolly aren't much harder.)
On 1.9L's
If you do it fast enough-neither. Remove the plug, be ready with the new one
really close by as the old one starts to come out. Install the new one. You
should only lose about a tablespoon of coolant.

Dave C
Williamsburg, VA
�����������������������

"Luke, try not. Do or not do. There is no try." - Yoda