Bill, Syncros have the same adjustment clamp between the front and rear
shift rods as 2WD models. Yes, it is possible to move it less than a
spline or I would not have suggested it. The male end has splines but
the female socket is smooth so this allows infinite adjustment when the
clamp is loosened.

Mark

Bill Davidson wrote:
>
> Hi Mark.,
> assuming you  information below applies to the Syncro...
>
> is 'the clamp' you are talking about below the same as the one shown in the
> upper right part of the diagram on page 34.20 of the bentley... the nut that
> secures the clamp is labeled "25Nm (18 ft lb) ??????
>
> also... is it possible to move it less than one spline??? though splined
> connections only move one spline at a time?
>
> Thanks
> Bill
>