In a message dated 12/26/2000 11:55:10 PM Eastern Standard Time, 
LISTSERV@GERRY.VANAGON.COM writes:

> Gary, I have seen the square drive at the hub of the front left wheel start
> to round off. This means that at a certain stage it will
> be engaging and disengaging. This will cause the needle to register
> unevenly. If this is your problem you may be able to move the cable a little
> to get it onto the square part but I am not sure.
> Regards, Ron Olsen
> 

       I have had success in welding to the end with a mig welder then filing 
the end square again so that it fits in the square hole of the grease cup.

Happy Holidays���

Frank Condelli
Almonte, Ontario, Canada
'87 Westy & Lionel Trains
Member: <A HREF="http://www.vanagon.com/">Vanagon List</A>, <A HREF="http://www.bcn.net/~limbo/">LiMBO</A>, <A HREF="http://www.westfalia.qc.ca/CIW_English.asp">IWCCC</A> & Capital City VW Club 
Vanagon/Vanagon Westfalia Service in the Ottawa Valley
<A HREF="http://members.aol.com/Fkc43/stebro.htm">STEBRO/Vanagon Stainless Steel Mufflers</A> �
<A HREF="http://members.aol.com/Fkc43/busindex.html">Frank Condelli & Associates</A> or http://frankcondelli.com
 

[text/html]