In a message dated 1/19/01 8:29:47 PM, JordanVw@AOL.COM writes:

<< i need the size of the socket that will remove the CV axle bolts..

is it 6mm or 8mm?    torx or allen?   12 point?
 >>

Chris,

You need an 8 mm triple square driver (i.e., 12 points).  Snap-on makes a
nice long one or you can get one at NAPA.  If you want to go cut rate, Napa
will sell you the driver blade without the 3/8 square socket adapter.  Just
plug it into an 8 mm socket with a small ball of duct seal or Strip-Calk on
the end to keep it in the socket Napa calls it an 8 mm Serrated Wrench, P/N
2304.  It is 3" long, USA made, therefore, properly hardened and tempered.