In a message dated 1/27/01 4:40:39 PM Eastern Standard Time, southard@GIS.NET
writes:

<< as I will
 be transplanting the Jetta TD engine into Reinhardt in the future and would
 like to move the Jetta pump along with the engine.  Any tips out there? >>

The jetta manifolds and such will not fit (well) in the vanagon If you have a
pump that doen't have the "high idle" linkage the van lever *should* fit.
line up that slot on the shaft to give a base location. you will need the
pump from the jetta with its aneroid for the boost enrichment. If you have a
metal engine lid the cross brace will need to be cut out to clear the bigger
"turbo" pump. the 85 and later plastic lids have a bigger "hole" in the foam
than do that 93-84's and clear the pump..almost..under hard acceleration in
reverse the engine "torques" enough that the pump contacts the lid..no BIG
deal..
Also..WILDLY recommend that installation of the "air cooled" vanagon gearbox
when installing the TD..
Err that should be the big stuff...

steve

"Hey! nice Jeep, Mister! "
"Look kid, it's NOTAJEEP! "