Well heck!

Just redid all my fuel lines on my 84 westy and replaced the injector
seals at the same time and was very proud that I didn't break anything
while doing it.

So this morning after doing one more check on all the fittings I hooked
the battery up, turned the key and ..... no start! I get power to the
fuel pump etc but the started doesn't do anything at all. I know that
the battery is in full charge and that the starter is good. Have I
knocked one of a zillion connections off or broken a wire or both? Since
all the fuel lines are empty.... is there anything in the system that
senses that and won't allow the ignition to kick over?

Any ideas would be greatly appreciated.

TIA
Bob
84 westy
Das Bus