In a message dated 2/25/01 12:09:40 PM Pacific Standard Time,
gwilke@LIVEMUSIC.ORG writes:

<< I'm about ready to swap my existing radio to one with a cd changer. There
is
 one screw that supports the existing basket in the back that seemed to be
 put in from the outside (front.)  Any hints to remove this puppy? Thanks >>

Geoff,

If you have a stock radio or similar, there is usually no nut in there. The
rear stud (bolt) attached to the radio and is simply held by friction to the
rubber plug which is in turn held in place by the metal holder attached in
back of the dash. Once you disengage the side clips at the front of the
radio, you should be able to pull the entire unit out. Take care to save the
rubber plug. You can reuse it for the new radio.

The plug will occasionally get stuck in the holder. It's easier to remove it
first. Then install on the new radio. Then push it all in it in as a unit.

BenT
San Francisco