

| Subject: | Re: K&N filter revisited with Pictures |
| From: | Karl Wolz |
| Date: | Sat, 10 Mar 2001 11:59:54 -0700 |
Malcolm, Apparently, Photopoint is case specific. To access your images, you must enter stebbins@AUCEGYPT.EDU. I took the liberty of looking at all of your images. The Coptic Monasteries are wonderful. you must be having a heck of a time. Karl Wolz ----- Original Message ----- From: "Stebbins" <stebbins@AUCEGYPT.EDU> To: <vanagon@GERRY.VANAGON.COM> Sent: Saturday, March 10, 2001 11:08 AM Subject: K&N filter revisited with Pictures > Sorry to open this thread again, but we just finished a 2500 > km drive around Egypt's "Desert Oasis Loop" and again we > drove over a lot of sand and through sand storms etc. and my > K&N filter is again very DIRTY. > > I took some pictures this time and they are at: > http://www.photopoint.com/ . Enter my email address ( > stebbins@aucegypt.edu ) in the upper right corner of the > page, where it says VISIT ALBUMS and the album is called > "K&N Filter Pictures", click on the thumbnail size > pictures, Note that there is an option for each picture > (down at the bottom right) to make the picture FULL SIZE. > If you have the band width, you may want to do this for the > detail. > > What I see here is a very dirty air filter, but the inside > of the carb plate is fairly clean. There is some bits of > sand on the inside on the plates, but not dirty. The top & > bottom plates over & under the filter are very oily and if > there was as much sand dust getting through the filter, I > would assume that the the inside of the carb would be about > as dirty, or at least show evidence of the sand dust getting > in past the filter to coagulate on the oily parts of the top > and bottom plates. > > I should also say that even with the dirty air filter, the > engine ran fine (we had other problems (coolant pipe burst) > but that's another story (coming soon to a list serve near > you :-)) > > I look forward to hearing what you guys have to say after > looking at the pictures. Malcolm >
Have something to add on this topic today? Revive this thread in the forum »