walter bahm wrote:

> Larry:
>
> what type of capacitor (rating) and across what two
> points dis you connect ?
>
> thanks
>
> walter
>
> --- Larry Alofs <lalofs@ENTERACT.COM> wrote:
> > Mark Dorm wrote:
> >
> > > Were any of the later model vanagons immune to
> > this sort of problem?
> >
> > My '91 had the problem. (Intermittent loss of power
> > at speed after about an
> > hour of continuous driving, generally in cold
> > weather.)
> >   I installed the capacitor, and it seems to run
> > smoother and idle down better,
> > but I am not sure if the main problem has been
> > solved since I haven't taken a
> > long trip in cold weather since.
> >
> > Larry A.
> > 91 GL  vinnie (Vincent Van Go)
>
> __________________________________________________
> Do You Yahoo!?
> Get email at your own domain with Yahoo! Mail.
> http://personal.mail.yahoo.com/

I got two 10 mfd tantalum capacitors off the rack at Radio Shack and
soldered them in parallel (hook the two positive leads together and the
two negative leads together).  I believe that R. S. can also order a
single 22 mfd tantalum for you if you prefer. A voltage rating of 10 or
15 V is plenty, higher is OK too.
 Connect the positive side of the capacitor(s) to pin 2 on the AFM
connector (blue and red wire on my '91).
  Connect the negative side to pin 4 (brown and white wire on mine).
I pulled back the rubber boot on the connector, scraped a little
insulation off the wires and soldered.  Tantalum capacitors are small,
so they fit inside the boot reasonably well.

Good luck.
Larry A.