At 07:45 AM 5/15/2001, puzerewski wrote:
>Here is the problem.  Coolant in the system, needle on gauge cluster all the
>way to the left and red light blinking.  Where is the sensor located? I
>figure there is a wire off.

The temp sender will give a zero gauge if it falls off.  I can't tell if
"left" is hot or cold in your case -- if hot, then check the wiring to the
coolant level sensor at the expansion tank.  Shorting that connection
should make the system think there is coolant.  If cold, then either the
level-sensor as above or else the blinker circuit in the gauge itself, or
the gauge is not getting enough voltage (needs 9.5-10.5v at the gauge).

david

David Beierl - Providence, RI
  http://pws.prserv.net/synergy/Vanagon/
'84 Westy "Dutiful Passage"
'85 GL "Poor Relation"