

| Subject: | Re: rebuilding throttle body |
| From: | Kenneth D Lewis |
| Date: | Mon, 21 May 2001 06:26:22 -0400 |
Good point. The obvious choice is JBWeld. Try it. Check it out in about a year and let us know if any came loose and was sucked into the combustion chamber. =8-0 Better yet, somebody send me some std/std main bearings so I can finish my spare engine and I will be glad to experiment with my 200K+ mile engine! Good Luck and Drive Safely Ken Lewis 86 Crewcab,60 356 http://Neksiwel.20m.com/ Good Luck and Drive Safely Ken Lewis 86 Crewcab,60 356 http://Neksiwel.20m.com/ On Sun, 20 May 2001 03:02:33 -0700 wayout <wayout@ix.netcom.com> writes: > Well... > Whether or not the butterflys are SUPPOSED TO touch the sides of > the > throttle body is entirely beside the point, because they DO! > > I believe that Marks original question (and now mine too) is : > > 1.) Can we resurface or fill in the grooves in the throttle bodies > to once > again make a positive seal with the butterflies? > 2.) By what method would list members suggest that this be done? > > Take care, > Jason Loewenstein > Marysville / Tulalip, WA > 85GL > > > > > > > At 01:31 PM 5/19/01 -0400, you wrote: > >Mark; > > I see what you are saying, I just do not understand why. > The > >butterfly are almost identical are they not? The throttle body's > should > >never close all the way anyway,if the idle stop is set correctly. > Why > >would it wear grooves in the side? > > > > > > > >Good Luck and Drive Safely > >Ken Lewis > >86 Crewcab,60 356 > >http://Neksiwel.20m.com/ > > > > > >On Fri, 18 May 2001 14:51:33 "Mark McCulley" > <transporter99@hotmail.com> > >writes: > > > Ken and Mark, > > > > > > The problem with the throttle body is quite different from the > > > problem with > > > worn bushings on a carburator. What typically happens with a > > > carburator is > > > the bushings on the butterfly plate shaft wear out resulting in > an > > > air leak > > > and a too-lean mixture. This is easily fixed by rebushing the > shaft. > > > What > > > happens on the 2.1l throttle body is the throttle plate wears > > > grooves into > > > the inside of the throttle body...................... > >________________________________________________________________ > >GET INTERNET ACCESS FROM JUNO! > >Juno offers FREE or PREMIUM Internet access for less! > >Join Juno today! For your FREE software, visit: > >http://dl.www.juno.com/get/tagj. > ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/tagj.
Have something to add on this topic today? Revive this thread in the forum »