I have over twenty years experience, but every malady is a new
adventure.  That's why I like these lists.  Usually there is someone
who is having or has had the very same problem or set of
circumstances.  I find it useful also to bounce various ideas as to
the cause and remedy off other enthusiast.  It keeps you thinking.

I just ordered a new F. P. regulator for my 87 Vanagon, but the
Vacumn is 12 #+ and the fuel pressure at idle is 33# so I think that
unit needs a new FPR.

If I didn't have so many VW's I think I'd have to much time on my
hands. This keeps me busy so I don't have time to beat my wife.

Steve

>Jeeze! Steve I've been looking at you like the guru.
>I can only recite how I solved the problem, I wasn't getting enough vacum
>to activate the fuel p Regulator and my motor was running very rich. The
>valve back off corrected it.
>
>Stan
>
>On Sun, 20 May 2001 18:07:04 -0600 "Steve Blackham" <steph@uswest.net>
>writes:
>>  I think (and hope) you're probably right.  I started with the lifters
>>
>>  at 1/2 turn on original assembly and tightened them to 1.5 turns
>>  after the 20 minute run in.  I think the combination of the higher
>>  cam, and higher pressure oil pump  must be affecting the valves
>>  closing correctly.  Resetting the valve adjustment is next .  Wish
>>  me
>>  luck!
>>
>>
>>  wilden1@juno.com wrote:
>>  Steve
>>
>>
>>  >Your valves may be just a tad too tight.
>>  >I've seen this on fresh engines.
>>  >The standard 2 turns on adjusting screws on hydraulic cams may just
>>  need
>>  >to be backed off 1/2 turn until you've gotten it warm a couple of
>>  times.
>>  >Best of luck!
>>  >
>>  >On Sun, 20 May 2001 16:08:34 -0600 Steve Blackham
>>  <steph@uswest.net>
>>  >writes:
>>  >>  I'm trying to tune up my freshly rebuilt 2 liter air cooled.  I
>>  can't
>>  >>  get it to breath correctly.  I have disconnected the crankcase
>>  >>  breather inlet, and aux air  valve at  the elbow but I still
>>  don't
>>  >>  get what I consider good vacumn.  2 #s at idle at the throttle
>>  body
>>  >>  and 6-7 #s at the distributor/ air distributor port.  Shouldn't
>>  my
>>  >>  idle vacumn be around 10-15 #s?
>>  >>
>>  >>  Any ideas?
>>  >>
>>  >>  Thanks Steve
>>  >>  --
>>  >>  Steve Blackham
>>  >>  Centerville, Utah
>>  >>
>>  >>  77 transporter converted to camper (Westy top)
>>  >>  83 Vanagon  (New and current project)
>>  >>  87 Weekender
>>  >
>>  >________________________________________________________________
>>  >GET INTERNET ACCESS FROM JUNO!
>>  >Juno offers FREE or PREMIUM Internet access for less!
>>  >Join Juno today!  For your FREE software, visit:
>>  >http://dl.www.juno.com/get/tagj.
>>
>
>________________________________________________________________
>GET INTERNET ACCESS FROM JUNO!
>Juno offers FREE or PREMIUM Internet access for less!
>Join Juno today!  For your FREE software, visit:
>http://dl.www.juno.com/get/tagj.

--

Steve Blackham  M.S.M.D.

"Is density a four letter word?"
http://www.ourcenterville.org/blackham/page1.htm

Centerville S.F. Bay Area Field Trip Slide Show
http://www.centervilleut.net/Govt/CommDev/UrbanVill/01_UV.htm