Yes, I buy the washers from list venders when I buy a
bunch of filters.
Might be able to make some from impervious
plastic,too.
Lots of FLAPS sell them- lots of sizes for fuel and
other auto systems.
I replace the crushers each time I pull the plug. And
save 'em for the next world-wide copper shortage. Geo.

--- Alan Bosch <arbosch@RA.ROCKWELL.COM> wrote:
> Volks,
> Some time ago, in Phred's distant and troubled past,
> some goof-ball,
> air-gun-toting, quicky lube-jiffy change,
> looking-for-the-engine-under-the-FRONT-of-the-bus
> type, mechanic (HA!!),
> musta cross threaded the oil drain plug back into
> the case (or maybe it was
> a dealer tech...?).  Anyhoo...  there's a heli-coil
> in the hole, as I found
> out over the weekend, and the copper crush washer
> used with the drain bolt
> does not seem to seal very vell, resulting in little
> drips of oil that my
> two-year-old started playing with today.
>
> Is it possible to get these crush washers in
> different sizes?  List
> vendors?  Or just FLAP-it...?
>
> Alan Bosch
> & Phred ('88 Wolfsburg)

__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year!  http://personal.mail.yahoo.com/