gang,

I need two parts to finish my '86 into a '90 engine install. can anyone
help?

1 - the elbow shaped, 2" diameter rubber hose that runs from (below) the
thermostat housing to the main rigid coolant line.
2 - the rubber, 1/2" (?) diameter hose that runs from the back (toward the
front of the bus) of the thermostat housing up to the plastic
        line above it that runs under the engine cover. this hose is larger
at the thermostat end than it is at the plastic nipple connection end,  and
it's about 6-8" long.

any help you can lend would be greatly appreciated.

i have some parts for sale as well;

complete exhaust - from a '90 (needs new cat. converter)
heat sheild - for over exhaust
air box - '86 or '90 (which begs a good question: if you put an '86 engine
in a '90 bus, which airbox will you use, the '86 or the '90?)
other stuff i can't remember - email me

thanks again

t