Aha - ok so just replace the arm - cool.  I also
understand one can pull the arm off - clean out loose
bits of metal - and tighten down snug - this will cut
new grooves in the wiper arm socket?

Tony

--- "Neal R. Hansen" <nhansen@dakotacom.net> wrote:
> I had the same problem. I found that the spline in
> the wiper arm goes bad. This is just soft Pot Metal
> and chews up easily, whereas the wiper shaft is real
> steel and the splines there don't.
> Not a very expensive fix.
>                                         Neal
>

__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/