Your best bet is going to be to take a new set of exhaust port gaskets
and take them to a welding fabrication shop that has either a flame
cutter or plasma cutter. They can cut near perfect flanges using the
gaskets as patterns and you can pick up the mandrell bends from your
local speed shop or muffler shop.

You may find some junk boxes cheap but getting the aluminum heatsinks off
is a world class PIA and the pipes inside probably won't have the strenth
you need to support a system.

Stan Wilder
83 Aircooled Westfalia

On Sun, 24 Jun 2001 15:46:55 -0700 Jack Lockamy <jacklockamy@ATT.NET>
writes:
> I'm looking for an exhaust manifold for an 80-83 Vanagon (aircooled)
> 2.0L.
>
> I am making a custom exhaust system and only need the portion of the
> exhaust that bolts directly to the "square" exhaust ports on the
> heads and extends down past the pushrods tubes.  No heat exchanger,
> mufflers, etc. required.  Just the exhaust flanges and about 6
> inches of down pipe to where it goes into the collector.
>
> If anyone has a used exhaust system that may have been replaced with
> new equipment....I would be interested in the flanges and downpipe I
> could use to weld a custom straight pipe system to.
>
> Contact me offlist please.
>
> Jack Lockamy
> Camarillo, CA.
> jacklockamy@att.net

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.