Hi,

I am assuming you have air conditioning and no power steering, as mine is.
Mine came with the double pulley on the crankshaft but my order was placed
as having power steering but no air conditioning.  Actually the opposite was
true, no power steering but with air.  Thus it should have come with a
single crankshaft pulley.  My belt configuration is as follows:  Inside
(towards engine) belt is the smaller of the two and runs from the crank
pulley to the air conditioning compressor.  The outside larger belt then
runs on the outer pulley groove on the air conditioning compressor, the
water pump, and the alternator.  I believe there are a few different
configurations of belts, and also four different sized belts depending on
accessories included.  These all are diagramed in the Tiico installation
instructions.

Good luck,

John Andrew 1984 "Westiico"
-----Original Message-----
From: Bill Knight <bill.knight@USA.NET>
To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM>
Date: Saturday, August 11, 2001 2:52 PM
Subject: TIICO: Crank Pulley

I was installing the accessories on my Tiico
engine and am stumped by how to connect the belts.
The pulley on the crank only has a single groove.
That just doesn't seem right, I would think two
grooves are necessary.

Can anyone enlighten me on this???

Thanks,
Bill Knight

____________________________________________________________________
Get free email and a permanent address at http://www.amexmail.com/?A=1