What color is the wire?  I can't see from the picture. Also, are you sure
that the black wire is supposed to connect to the gray one?  That doesn't
look right...

My guess is that your wire in question is the fuel pump wire.

Bill

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com]On Behalf
Of Sean B.
Sent: Wednesday, September 05, 2001 10:15 PM
To: vanagon@GERRY.VANAGON.COM
Subject: TIICO wiring Question.

Last weekend I got the wiring harness for my new TiiCo motor installed
(along with the engine itself, but that's a separate post). The wiring went
rather smoothly. I was able to identify where ALMOST everything was
supposed to go. My question has to do with that little black box on the
driver's side firewall. One "branch" of the harness is supposed to go in
there. There is a round connector with 8 (I think) wires in it. No brainer.
There is a red wire with a screw terminal connector on the end of it, again
no brainer, it goes on the screw stud with the other red wire. The big
question is... what does the yellow insulated spade connector plug into?

There is a picture of what I'm talking about at the URL below.

http://www.vgonman.com/tiicowiring.htm

Thanks in advance for any help that you volks can give me.

The victim is a 1990 2WD V'gon with an autotragic transmission.

Sean B.
'90 V'gon, "Happy Bus", pseudo Wolfy
Torrance, CA
HTTP://www.vgonman.com