On 14 Sep 2001 at 11:13, Peter Krogh wrote:

> I'm going under the van for the cooling system repairs.  What is the
> preferred way to lift it up for this.  I have a level concrete driveway to do
> the work on.
>
> Cost, manufacturer, part numbers, distributor info appreciated.  I don't mind
> spending a few bucks on this (I'll pretty much always spend money on tools).

When I pulled my trans to do the pilot bearing, I used my floor jack to
raise the rear of the van, then supported each side with a jackstand on
the frame rails just inboard of the jack points, with a piece of 2x4 on
each stand to cushion/distribute the weight on the frame.
I have also done the same on the front end, but never both at once,
since I only have 2 jackstands.
I would not even both with ramps - I have a set and find they are a pain
to use and too often slip out while trying to drive up. The only exception
is if you can place ramps on very rough concrete, or gravel to avoid
slippage.

========================
Shawn Wright
Computer Systems Manager
Shawnigan Lake School
http://www.sls.bc.ca
swright@sls.bc.ca