At 23:40 11/10/01 -0400, you wrote:
>Subject: Re: TIICO... It's Alive!!
>
>I was wondering if the flexible exhaust lines could be used somewhere to
>eliminate this muffler problem.  My Honda has one.  Is there a source for
>this stuff?

 Indeed there is...at least here in Oz so I'm sure they're available
 elsewhere.
 I have seen flexible sections of exhaust lines here at good exhaust
 shops in 150mm (6") and 300mm (12") sections in flexable braided stainless
 steel with a piece either end to join up to the rest of the exhaust pipe.
 Don't know what variety of diameters are available but the ones I've seen
 were around the 50mm (2") mark...
 You may not find them at the local Midas Muffler type establishments
 but good places geared towards older vehicle restorations should be able
 to help.
 I had need to use one of these recently restoring an old railway section
 car to provide a flexible joint in the exhaust pipe as the old two stroker
 rattles,bangs & farts and fixed pipes fatigue in a short time.
 The flexible section works very well and the exhaust has never given
 trouble since :)
 You can have a look at this thing for anybody who cares at:
 http://www.cobweb.com.au/~nldoncas/steve_overmyer.htm
 but you can't see the exhaust section I'm talking about.
 For VW content however it does run a 6V VW battery,VW fuel line
 and a bay window Kombi flexable heater tube between the air filter
 and carb.Afterall,that's what I had lying around :)

 OVC.My '92 has dragged this thing on a trailer over much of the
 country and with 217,000kms now on the clock still has it's
 original clutch.The 5 sp box runs synth oil and has never needed
 to be looked at...reaching for wood as I type ;)

 Cheers,
 Steve O
 Blue Mountains NSW Aust.
 '92 Transporter WBX Kombi
 '76 Transporter Double Cab
 '68 Beetle
 '00 Transporter 5Cyl Double Cab (work truck)

>"Sean B." <vgonman@EARTHLINK.NET> on 10/11/2001 03:52:49 PM
>
>Please respond to vgonman@EARTHLINK.NET
>
>To:   vanagon@GERRY.VANAGON.COM
>cc:    (bcc: Jay L Snyder/AE/DuPont)
>Subject:  TIICO... It's Alive!!
>
>
>
>
>I am happy to report that my TiiCo conversion is FINALLY moving under its
>own power! WOW! Much smoother than the WBX. My only beef is that the
>muffler still hits the bodywork, even after quite a bit of bending of the
>rear valence near the passenger side bumper bracket. Oh well, when I was
>putting it in I noticed the sound of small pieces rattling inside it (yes,
>just the muffler, not the cat. this has been confirmed), so I think I'm
>going to hunt down some flavor of Dynamax to stuff under there.
>As soon as I can get to my mechanic (hopefully tomorrow morning) and get
>the CO% set I'll be driving it to work again. I'm so glad :)
>Sean B.
>'90 V'gon, "Happy Bus", pseudo Wolfy
>Torrance, CA
>HTTP://www.vgonman.com