Skip to main content
Gerry | Vanagon
Checking account...
← vanagon.com home · Continue the discussion in the forum
Subject:Re: Light wiring and little plastic caps
From:Shawn Wright
Date:Sat, 10 Nov 2001 13:11:47 -0800

On 9 Nov 2001 at 23:16, Phil Walker wrote:

> I've searched the archives, but I can't seem to find the answer...
>
> Is there any way to get to the overhead Westy light without removing the entire tray? I'd like to run my wires to the back of the van from this light, but I'd rather not do a lot of removal. Which leads to my next question.

I don't think so. This is what I did to run wire to an extra light under the
rear upper cabinet.

> A) Is there a way to remove the little plastic caps on the screws without damaging them (I haven't found it yet).

I use a small sharp knife blade to slip under the edge and carefully pry off.
Even with this, I've marked a few of them up, but it's better than using
pliers or a screwdriver.

> B) Is is possible to buy these caps in bulk? I looked at Busdepot and Vanagain and I don't see them. Is there another vendor out there. I've even looked in McMaster Carr and Grainger to find something similar. No such luck. Maybe I should just pull them all off, then I wouldn't know the
difference.

Maybe the dealer? I bought new screws for the front luggage rack and the
dealer ordered them in (prepainted!), not too expensive considering the
odd size is nearly impossible to match.

Shawn Wright
http://zuiko.sls.bc.ca/~swright
'85 Jetta TD
'88 Westy 2.1L