> i am wondering if it is worth fixing.

Probably\

. i can move the rocker arm of the intake
> valve of cylinder #1 about an inch. the spring on that valve doesnt move,
> what moves is the bottom half, what i would call the push rod, if this
> thing has push rods.

I would remove this rocker arm.  It is an 11mm nut that holds it on and do
not loose it.  carefully remove that wire piece that retains the pushrods
first.  Now at this point there is no pressure at all on the valve stems.
Do they line up the same on intake and exhaust on number one, or is number
one sticking out further from the head?  I f both are straigt, proceed to
next step.

Then I would remove the pushrod.  I would look down in there and see what is
going on with a flashlight.  My best luck in removing the lifter is to hook
it with a seal puller, although sometimes a magnet pulls it right out.  My
guess is that you will see a lifter that has lost its snap ring and fell
apart.  Maybe not though.........It could be a collapsed valve seat meaning
a new head........... If so, not the end of the world, either.  I would
sheck the strainer and see what sort of metal is in the screen before
committing, though.

>
> so is this a problem with the hydraulics in this valve? if so, are the
> hydraulics part of the head and all i need to do is simply put a new head
> on?

The hydrtaulics are the lifters...they pump up eith oil.

what other problems am i looking at in terms of damage to that
> cylinder and other parts of the engine?

Tough to say without more info.

>
> any help on this matter would be appreciated. Thanks.
> david
>