Here's the instructions for O2 sensor splicing.
Thanks to Ron at Bus Depot for the Extraordinary Service!
I'm new to the list and this is my first order to Bus Depot,
won't be my last. Thanks, Ron for your fast response.

Paul Mayfield

> Today I ordered an O2 sensor fr Bus Depot.
> They said that instructions were not included,
> suggested I check the list archives.
>
> Frank G. wrote: "Which wire goes where?? See the archives"
> "Such details are well covered in the archives
> (redundant hint). Which wire goes where?? See the archives"
>
> I have searched archives and have not
> yet stumbled on instructions to splice
> the Bus Depot $39.95 sensor to the
> Vanagan connector.

Ron at Bus Depot writes:

There are one black and two white wires. The whites are interchangeable so
it's easy to figure out which goes where. Cut the factory plug off of the
old sensor, a few inches from the plug.  Cut the generic Ford plug off of
the new sensor at about the same place. Splice the factory plug from the old
sensor in place of the generic plug on the new one.  You want a good
connection that will also be relatively waterproof so your sensor doesn't
ground out the first time you hit a mud puddle.  Solder it. Or use one of
several waterproof splicing connectors available very inexpensively at Home
Depot, etc, which are designed for splicing outdoor electrical wiring.  Just
don't twist them together and cover them with duct tape. :-)

- Ron Salmon
  The Bus Depot, Inc.
  (215) 234-VWVW
  www.busdepot.com