But don't you hit the gas tank???

Matthew Pollard          "Racing with the wind and flirting with death
Dept. Of Chemistry        So have a cup of coffee and catch your breath"
University of Idaho
www.uidaho.edu/~poll7356

On Tue, 4 Dec 2001, Karl Wolz wrote:

> Pretty sure that I used a 13mm socket (perhaps with an extension?), but
> could have been a combo.  I know I didn't have anything exotic with me under
> there.
>
> Karl Wolz
>
> ----- Original Message -----
> From: "Matthew Pollard" <poll7356@UIDAHO.EDU>
> To: <vanagon@GERRY.VANAGON.COM>
> Sent: Tuesday, December 04, 2001 12:05 PM
> Subject: how to tighten starter wire nut??? Syncro
>
>
> > what wrench does one use to tighten the starter wire nut? I can get
> > combination wrench over it and but have no room to move it up and
> > down to loosen/tighten.  Do i need an "S" shaped 13mm? Offset?
> > thanks
> > matthew
> >
> > Matthew Pollard          "Racing with the wind and flirting with death
> > Dept. Of Chemistry        So have a cup of coffee and catch your breath"
> > University of Idaho
> > www.uidaho.edu/~poll7356
>
>