Yes, just did mine.
you need all the parts ALL the parts..and then ,as the front to rear wiring
is part of the main harness, a set of 3 wires to run front to rear on your
car..I use the 4 wire trailer light ribbon and it works fine.
the pump goes in the right rear corner, the actuator goes on the left hand
manifold the switch on the column, the break and clutch switches mount to
existing holes, the "brain" goes on a panel behind the glove box.. there is a
"plug and play" set of wires for your brakelight switches and the power comes
off the terminal on the back of the fues box (if you are REAL cleave you can
reach it W/O pulling down the fusebox) the speed sensor goes in the back of
the speedo (after breaking out the obvious tab) and, well, wires and hoses
plugged on  and it works!

Steven M. Denis
3642 Longleaf Drive
Elm City, NC 27822

"Hey! nice Jeep, Mister! "
"Look kid, it's NOTAJEEP! "