This is not a Vanagon question, but I have a lot of faith in this list(and I
don't know where else to ask this question).  If I'm out of line, does
anyone know a Bug list that is as good as this one.

I am resealing the final drive covers on a 1966 Bug, swing axle, and having
removed everything, including the differential and those special shims(S1 &
S2) that set the ring gear position, find that I am a bit unsure as to which
side of the differential one of them(the shims) came off of.  These shims
slide over the tube like parts of the differential housing that the
differential side gears fit into.

There are only two types of these shims, the thick ones(2-4 mm) and the thin
ones (.25mm).  I know that on this transmission, one side, the clutch lever
side(driver's side) had one thick(3.5mm) shim and one thin(.25) shim.  Of
that I'm sure.  But I have one more thick shim(3.3mm) and I didn't mark
which side it came off.  I'm 99% sure that it goes on the other side(the
passenger side) because it makes no sense that there would be two thick
shims(and one thin) together on the one side.

But I want to be 100% sure of this because I don't really want to have to do
this all over again in the event there is a ring and pinion howl after I
take my first test drive.  Can someone  help me out with this?  I'm sure
it's an easy question for a trans rebuilder, but I don't know one I can call
on at this time.

Thanks,

John